Manualshelf

Owner's Manual

ManualsBrandsYamaha ManualsDJ EquipmentDM2000
231232233234235236237238239240
226 Chapter 20—Remote Control
DM2000—Owner’s Manual
Configuring MTR Track Arming
You can assign MTR machine tracks to the TRACK ARMING [1–24] buttons as follows.
These assignments are effective only when the TRACK ARMING [MASTER] button indi-
cator is off.
1 Use the TRACK ARMING [DISPLAY] button to locate the MTR Track Arming
Configuration page.
2 Use the cursor buttons to select the parameters, and use the Parameter
wheel, INC/DEC buttons, and [ENTER] button to set them.
MACHINE: This parameter is used to specify the MTR machine whose track is to be
armed when each TRACK ARMING button is pressed. Only machines configured as MTRs
on the Machine Configuration page (see page 220) can be selected.
TARGET TRACK: This parameter is used to specify the MTR machine track that is to be
armed when each TRACK ARMING button is pressed.
Configuring Master Track Arming
You can assign Master machine tracks to the TRACK ARMING [1–24] buttons as follows.
These assignments are effective only when the TRACK ARMING [MASTER] button indi-
cator is lit.
1 Use the TRACK ARMING [DISPLAY] button to locate the Master Track Arming
Configuration page.
2 Use the cursor buttons to select the parameters, and use the Parameter
wheel, INC/DEC buttons, and [ENTER] button to set them.
MACHINE: This parameter is used to specify the Master machine whose track is to be
armed when each TRACK ARMING button is pressed. Only machines configured as Mas-
ters on the Machine Configuration page (see page 220) can be selected.