Owner's Manual

Other Functions 269
DM2000 Version 2—Owner’s Manual
21 Other Functions
Using the User Assignable Layers
If you set the Remote layer target to “USER ASSIGNABLE,” you can create a custom layer
by combining any DM2000 channels (excluding the Stereo Out).
1 Use the DISPLAY ACCESS [REMOTE] button to locate Remote 1–4 page.
2 Use the cursor buttons to select the TARGET parameter, use the Parameter
wheel or INC/DEC buttons to select USER ASSIGNABLE LAYER, then press
[ENTER].
A confirmation message appears. Select the YES button and press [ENTER].
3 Use the cursor buttons to select parameter 1–24, use the Parameter wheel
or INC/DEC buttons to select a channel you want to assign, then press
[ENTER].
You can store up to four 24-channel setups in four banks by switching Banks 1–4 via the
BANK 1–4 buttons.
Pressing the [ENTER] button prior to selecting assigned channels enables you to select a
channel in the User CH Select window.
4 Use the LAYER [REMOTE 1]–[REMOTE 4] button to recall the User Assignable
layer assigned to the Remote layer.
You can use the faders, Encoders, [ON] buttons, [AUTO] buttons, and [SOLO] buttons to
control assigned channels. If you connected an optional MB2000 Meter Bridge, its meters
indicate the level of the channels currently-assigned to layer channels 1–24.