DM2000-v2 Short-Cut List
Using the ‘SEL’ switches 1. CHANNEL PAIR Hold ‘SEL’ for one channel and press ‘SEL’ for the adjacent channel to make a stereo pair. This works for input and output channels, so long as the left side is an odd number and the right side is an even number. The channel with the SEL switch you hold first is the master channel for the pair: its settings are copied to the other channel (except for pan and bus routing). Repeating this action breaks the stereo pair, to make the channels mono again. 2.
Other Short-Cuts 1. EQ Gain to 0dB To reset the gain of an EQ band to 0dB, press and hold the Freq/Q encoder for one second. 2. EQ Reset To return the whole Parametric EQ for a channel to its default settings, press the Freq/Q encoders for the LOW and HIGH bands at the same time. 3. AUX ON/OFF To access the AUX ON/OFF switches quickly, press and hold the required AUX SELECT switch. Then the CHANNEL ON switches above the faders become the AUX ON switches for the selected Aux.
5. Copy STEREO Mix to an AUX Press and hold an INPUT FADER LAYER switch, then press an AUX SELECT switch, and click YES in the confirmation box on the LCD. This copies the fader levels to the selected AUX sends. Make sure the Aux sends are all PRE by clicking the GLOBAL PRE switch on the SEND1-24 page in the AUX DISPLAY menu. NOTE Repeat the same procedure for each fader layer to copy the whole mix to the Aux sends, as only one layer is copied at a time.
Other Tips 1. GROUP ASSIGN The default settings of USER DEFINED KEY bank F is for INPUT GROUP ASSIGN functions. Keys 1-8 are for Input FADER GROUPS, and Keys 9-16 are for Input MUTE GROUPS. To assign a channel to a group, select the channel and press the relevant USER DEFINED KEY in BANK F. The USER DEFINED KEY will then light up to confirm the assignment. NOTE A Channel cannot be in more than one FADER GROUP at a time, and cannot be in more than one MUTE GROUP at a time. 2.
4. Remote Control of AD824 or AD8HR Units To remote control the Head-Amp settings of these units. Select HA as the REMOTE FUNCTION in the REMOTE page of the SETUP menu. Then select which slots are used for which units (the Unit ID is displayed on the front panel of the remote AD units). Assign one of the ENCODER MODE ASSIGN keys to HA Gain so the input Gain can be controlled from the Channel Encoders. PHANTOM POWER can be controlled from the HA CTRL page in the PHASE/INSERT menu. 5.
. Use the same Studio Monitors for Surround and Stereo Monitoring To allow this, switch on the MONITOR L/R TO C-R option in the SURROUND page of the MONITOR menu. Then the Front Left and Right speakers can be connected to the Control Room outputs while the other Surround speakers can be connected to spare OMNI or SLOT Outputs. When mixing in Surround, turn the CONTROL ROOM LEVEL pot up to maximum, and use the SURROUND MONITOR LEVEL pot as the listening level.
10. Initialize Memories To erase all the memories in the console and return it to is initial settings, first switch off the console. Then switch it on again while holding the SCENE STORE switch. Choose INITIALIZE to erase all the libraries and return to the default settings. Check for the latest downloads at www.yamahaproaudio.
