Setup Instructions

DME-N Network Driver Setup Details
DME Setup Manual 25

“Advanced Settings” dialog box
Click [Advanced Settings] in the DME-N Network Driver dialog box to display the Advanced Settings dialog
box. The parameters presented in this dialog box are used to setup automatic detection by the DME-N
Network Driver; furthermore, setup files can also be imported and exported here.
 Auto Detect
Allows automatic detection of connected devices
that can communicate with the DME-N Network
Driver. A maximum of 254 addresses (***.***.***.1
through ***.***.***.254) can be detected.
n Only MAC addresses of devices on the same subnet as
the computer can be detected. Before searching for
MAC addresses make sure that the computer is
connected to the subnet to be searched, and that an
appropriate IP address is assigned.
1 Detect from
Specifies the start IP address for automatic detection.
2 Detect to
Specifies the end IP address for automatic detection.
3 currently searching
Displays the IP address being checked during
automatic detection. No display when automatic
detection is not in progress.
4 [Start] Button
Initiates automatic detection, and causes the detected
device list (6) to be updated accordingly. This button
is grayed out and is not accessible during automatic
detection.
5 [Abort] Button
Aborts automatic detection. This button is grayed out
when automatic detection is not in progress.
6 Detected Device List
This list shows all detected devices that are capable
of communication with the DME-N Network Driver. No
devices will be displayed initially.
[Add]
Checked devices will be added to the Target
Device List when the [Add to Device List] button
(below) is clicked. Devices that are already
registered cannot be checked.
[Device IP Address]
The IP address of the corresponding detected
device.
[Device Name]
If a name has been registered for the detected
device it will be displayed here, otherwise no name
will be displayed.
Device MAC Address
The MAC address of the corresponding detected
device.
7 [Add to Device List] Button
Devices with checked [Add] checkboxes will be
added to the Target Device List when this button is
clicked.
8 [Cancel] Button
Closes the dialog b
ox without making any changes.
9 [Import Setup from File] Button
When working in a different environment it is possible
to load a previously saved setup file. Click to open the
“Open” dialog. Select a setup file and then click the
[Open] button to import the corresponding settin
gs.
) [Export Setup to File] Button
It is possible to save the setup data to a file that can
then be reloaded when working in a different
environment. Click
to open the “Save As” dialog.
Enter a file name and click the [Save] button to
save the setup file.
2
3
4
5
8
)
6
7
9
1