Owner's Manual

Chapter 3 Main Panel Window
DME Designer Owner’s Manual
186
DME Firmware Update
You can update the DME or SP2060 unit, ICP1 firmware using the [Firmware Update] command on the
[Hardware] menu. When you move the mouse cursor over the [Firmware Update] command on the
[Hardware] menu, a submenu is displayed.
When you select [Program+Component] or [Recovery Update] on the submenu, the folder select
dialog box will be displayed.
When performing a firmware update, connect the DME or SP2060 unit, ICP1 and the computer.
When the DME or SP2060 unit, ICP1 update is finished, the DME or SP2060 unit, ICP1 will be
automatically restarted. You also need to restart DME Designer.
NOTE
When performing the DME or SP2060 unit firmware update, connect the DME or SP2060 unit and the computer by USB or
Ethernet. The USB-MIDI or DME-N Network Driver must be installed in the computer.
NOTE
To perform the ICP1 firmware update, the ICP1 and the device group master DME unit must be connected by Ethernet. In
addition, the device group master DME unit must be connected to the computer as described above.
NOTE
If the DME64N/24N has been updated from V1.07 or earlier to V1.10 or later, perform the update twice. Because the text
display data in the DME64N/24N unit is changed, text display for Japanese is not possible with one update only.
NOTE
It may be impossible to complete the firmware update, and “Error” may occur in the Status field if the [Remaining Memory]
value (the amount of remaining DME memory) (page 111) becomes too small. If this occurs, delete unwanted data such as
DME File Storage files, Library data, and scene data to increase the amount of available memory.
NOTE
You can download the latest firmware from the following Yamaha Pro Audio website.
http://www.yamahaproaudio.com/