Installation guide

DME-N Network Driver Installation Guide for M7CL 3
To operate your Yamaha hardware from your computer via Ethernet, you'll need to install the DME-N Network Driver
software.
DME-N Network Driver is software that transfers MIDI data back and forth between your computer and the
hardware via Ethernet cable.
Connect the computer to the M7CL by using an Ethernet cable via a hub. When you connect the computer to the
M7CL directly, use a crossover cable.
DME-N Network Driver applies to the system requirements of M7CL Editor. Refer to the M7CL Editor Installation
Guide for details.
1 Extract the data from the downloaded compressed file and open the “DME_Networkdrv_v***” folder.
“***” represents the version number.
2 Double-click on “Setup.exe.”
When the setup has been initialized, a “Welcome” window appears.
3 Click [Next]. The YAMAHA DME-N Network Driver will be installed.
When installation is complete, a message appears indicating that setup has been completed.
4 In order for the newly installed YAMAHA DME-N Network Driver to take effect, select “Yes, I want to
restart my computer now,” and click [OK].
The computer will restart.
The YAMAHA DME-N Network Driver has been installed.
DME-N Network Driver
Connection of computer and the M7CL
Minimum System Requirements
Installation
Ethernet cable
M7CL
Computer
Editor
Ethernet cable
Hub
or
Crossover cable
Driver