User Manual

Chapter 3 Main Panel Window
DME Designer Owner’s Manual
168
MIDI CH
Sets the MIDI channel. This number is also used as the Parameter Change Device ID.
[Tx]
Select the MIDI transmit channel from the list.
[Rx]
Select the MIDI receive channel from the list.
Program Change/Control Change/Parameter Change
Sets transmit (Tx), receive (Rx), OMNI, and Echo for program change/control change/parameter
change. When ON, clicking turns this OFF. When OFF, clicking turns this ON. When OMNI is [ON]
channel messages are received regardless of the receive channel setting. When ECHO is [ON] the
input data is “echoed” (re-transmitted) via the output port that corresponds to the input port via
which it was received.
Program change, control change, and parameter change details can be set up via the “MIDI”
window [Program Change], [Control Change], and [Parameter Change] tabs, respectively.
GPI Tab
Calibrates the input voltage detection range for a DME unit GPI terminal.
[ALL] Checkbox
Automatically checks all channel checkboxes.
[Ch] Checkbox
These checkboxes specify the channels to be calibrated.
Calibration Information
Displays the input voltage in real time.
[Reset] Button
Resets the calibration of checked channels.
[Max] Button
Sets the current input voltage as the maximum input voltage for checked channels.
The specified maximum voltage is indicated by a red bar.
[Min] Button
Sets the current input voltage as the minimum input voltage for checked channels.
The specified minimum voltage is indicated by a blue bar.