User Manual

Chapter 6 Component Guide

DME Designer Owner’s Manual

412

Low Pass Filter (LPF)

The low pass ﬁlter passes frequencies in the signal that are lower than a speciﬁed frequency, while

attenuating higher frequencies in the signal. There are two types of LPF components: mono channel

and stereo channel. Mono channel LPFs have one input and one output. Stereo channel LPFs have

two of each.

Double-click a component to display the component editor for it. The parameters are the same for

mono channel and stereo channel components.

Section Parameter Setting Range Function

1 Input Level -∞ to +10 dB Sets the input signal level.

2 Phase ON/OFF Reverses the phase of the input signal.

3 LPF Frequency 20 Hz to 20 kHz Sets the cutoff frequency.

4 Slope 6 dB/Oct

12 dB/Oct

Sets the attenuation for each octave.

5 Bypass ON/OFF Turns bypass ON.

6 Output Level -∞ to ±0 dB Sets the output signal level.

3 4 6

LPF component editor