User Manual

Advanced Setup
DME Setup Manual 19
7 Select the DME unit that is to function as
the Device Group Master from the Target
Device List, enter the Device Name and
Device Port No., and click the [Apply]
button.
Device Name
Displayed as the port name in DME Designer.
Device Port No. (MIDI port number)
Set to “1.” “2” is also available for DME64N/24N
devices.
8 Click the [Save and Close] button to close
the dialog box.

Going On-Line
1 Place and connect the required
components as described in the basic
setup procedure (page 7) beginning from
step 1-1.
2 Click the [On-line] button from the Main
Panel window.
3 Click “Select IP Address”, ensure that the
IP addresses for all devices are
displayed collectly, and then click the
[Go On-Line] button.
4 When the Sync Direction window is
displayed, ensure that [DME Designer ->
Device] is selected, and then click the
[OK] button.
Check sound output as described in the Basic
Setup section (page 12).