User Manual

DME Setup Manual 23

“DME-N Network Driver” dialog box
Select [Start]  [Control Panel]  [DME-N Network Driver] to open the “DME-N Network Driver” dialog box.
The parameters in this dialog box set up the device information of the DME on the network.
1 Target Device List
The name, IP address, MAC address, and MIDI port
number of all devices registered to communicate
with the DME-N Network Driver are shown in this list.
Click the title bars to sort accordingly.
When a device is selected in the list, information
related to that device will be viewed and edited in
the Device information (2) area below the list.
Device Name
Device IP Address
Device MAC Address
Device Port No.
These fields display the name, IP address,
MAC address, and MIDI port number of the
corresponding devices. Refer to the Device
information (2) area for more details.
[New] Button
Click this button to add a new device to the list.
Edit the device’s parameters as required via the
fields in the Device information (2) area below the
list, the click the [Apply] button to add the specified
device.
[Duplicate] Button
This button adds a device to the list by copying the
data from the currently selected device. Edit the
new device’s parameters as required via the fields
in the Device information (2) area below the list,
then click the [Apply] button to add the specified
device.
[Remove] Button
Deletes the selected device from the list. If the
removed device is not the lowest device in the list,
all devices below the removed device will be shifted
upward to maintain the continuity of the list.
[Remove ALL] Button
Deletes all devices from the list.
[Undo] Button
This button provides a one-step undo function that
allows you to undo a single operation and revert to
the previous state. The [Undo] button will be grayed
out and inaccessible immediately after an undo
operation or after the control panel is launched.
2 Device information
When a device that is registered for communication
with the DME-N Network Driver is selected in the
Target Device List, the communication parameters
for that device can be viewed and edited in the
device information fields.
[Device Name]
This is the name of the device selected in the
Target Device List. The initial default settings are
“UNIT1” through “UNIT256”, but the name can be
edited as required in this field.
[Device IP Address]
The IP address of the device selected in the Target
Device List can be set via these fields. Refer to
page 16 for details on checking and setting its IP
address.
n The IP address must be set properly or
communication with the device will not be possible.
[Device MAC Address]
The MAC (Media Access Control) address of the
device selected in the Target Device List can be
set via these fields. The MAC address of each
device is permanently assigned when the device is
manufactured and cannot be changed. The MAC
address parameter is included to prevent data
from being sent to the wrong device if the IP
address in inadvertently set incorrectly.
n The MAC address must be set properly or
communication with the device will not be possible.
n The Device MAC Address setting cannot be
changed for the device connected to the network.
DME-N Network Driver Setup Details
3
1
2