User Manual

4. Command Sequence
The following are examples of the main command sequence.
A parameter change (executed by Remote Controller)
A parameter set command
DME
SPR 0 1 0 (setting parameter 1 to 0)
Remote Controller
SPR OK (ACK from the DME)
PRM 0 1 0 (parameter 1 is set to 0)
A parameter change (executed by other than Remote Controller)
DME
A parameter set command
Remote Controller
PRM 0 1 0 (parameter 1 is set to 0)
Obtaining a parameter
DME
GPR 0 1 (obtaining parameter 1)
Remote Controller
GPR OK (ACK from the DME)
PRM 0 1 0 (current value for parameter 1 is 0)
Scene recall (executed by Remote Controller)
DME
RSC 0 1 (recalling scene 1)
Remote Controller
RSC OK (ACK from the DME)
SCN 0 1 (scene 1 is recalled)
Scene recall (executed by other than Remote Controller)
DME
Remote Controller
SCN 0 1 (scene 1 is recalled)
Obtaining current scene information
DME
GCS (obtaining the current scene number)
Remote Controller
GCS OK (ACK from the DME)
CSN 0 1 ("1" is the current scene)
Command to obtain a level meter
DME
GMT 0 1
(obtaining a meter registered in "1")
Remote Controller
GMT OK (ACK from the DME)
MTR 0 1 -100 -500 -200 …
(meter registered in "1" is obtained)
DME Remote Control Protocol Specifications V3.1
17