Owner's Manual
Table Of Contents
- Foreword
- Introduction to the DME64N/24N
- The Controls and Connectors
- Preparation
- Connecting to a Computer
- Audio I/O Connection
- Connecting to an External Device
- Panel Operation and Displays
- Basic Operation
- Main Display
- Parameter Edit Displays
- Spectrum Display
- Level Meter Display
- Initializing the DME64N/ DME24N
- Utility Displays
- Items accessible via the Utility display
- Utility Display Operation
- Info Page
- Network Settings (Net) Page
- Display Setup (Disp) Page
- Security Setup (Lock) Page
- Miscellaneous Setup (Misc) Page
- Word Clock Setup (WCLK) Page
- Slot Information (Slot) Page
- MIDI Setup (MIDI) Page
- GPI Setup (GPI) Page
- Head Amplifier Setup (HA) Page
- Cascade Setup (CASCAD) Page
- Check Page
- References
- Index
Audio I/O Connection
DME64N/DME24N Owner’s Manual
26
Analog Audio Connection ([IN] and [OUT] Connectors) (DME24N only)
The DME24N includes [IN] and [OUT] connectors for 8 channels of analog audio input and output. Wire
the supplied Euroblock plugs as shown below. Head amplifier gain and phantom power settings can be made
via the Utility display HA page described on page 52 of this manual, or via the DME Designer application.
Euroblock Connection
1.Prepare cables to be attached to a Euroblock plug as shown below.
Be sure to use shielded cable.
Do not tin (plate with solder) the exposed sections of the cable.
2.Loosen terminal screws.
3.Insert cables.
4.Securely tighten terminal screws.
Pull the cables (not too strongly) to confirm that they are securely connected.
Audio I/O Connection
NOTE
A slotted screwdriver with a blade width of about 3 millimeters is recommended.
3mm
7mm
30mm
Shielded Cable
CAUTIO
N
WARNIN
G
Loosen.
Euroblock Plug
Slotted Screwdriver
Ter minal Screw