User Manual

Example Program for Crestron - Setup Guide -
2
Tested Firmware Versions
PRO2 processor : 3.155.1240
TPS-12W touch panel : 3.001.0035
The program has been tested using the above firmware combination. Different firmware
combination could cause unexpected behaviour. Please refer to the Crestron website
to check firmware update history.
File list
Please download and unzip all of these files:
YamahaCA_Crestron_ExampleV1.0_Programming.zip
SIMPL Windows files for compiling and uploading to the processor. Written for PRO2.
YamahaCA_Crestron_ExampleV1.0_TP.zip
Files for uploading to the touch panel. Written for TPS-12W. Also supports an XPanel.
YamahaCA_Crestron_ExampleV1.0_DynamicContentRev1.2.zip
Language and image files. Transfer using File Manager in the Toolbox application to the
processor.
YamahaCA_Crestron_ExampleV1.0_YamahaDevices.zip
Studio manager files for mixers, and configuration files for DME processors and IMX644
installation mixer.
YamahaCA_Crestron_ExampleV1.0_SetupGuide.pdf
This Setup Guide
Protocol Specification documents
Each Yamaha device protocol specification document is available as below.
DME24N/64N/DME4io-C : Protocol document on Yamaha web site
01V96, M7CL, LS9 : Protocol document on Yamaha web site
IMX644 : Described in owner’s manual
BD-S2900 : Please contact your nearest Yamaha branch
Assigned IP address
IP addresses for all the system components.
192.168.0.101 DME24N
192.168.0.102 DME64N
192.168.0.103 DME4io-C
192.168.0.211 Crestron PRO2 processor
192.168.0.212 Crestron TPS-12 touch panel
The device configuration page on the touch panel has pre-configured IP addresses for
Yamaha devices. You need to set these identical IP addresses in to the connected
Yamaha devices. If you require different IP addresses, these must be modified in the
Crestron source code before compiling.