User Manual

Chapter 3 Main Panel Window
DME Designer Owner’s Manual
136
DAW Control
When you click [DAW Control] on the [Tools] menu, the “DAW Control” dialog box is displayed. Here
you can make settings for when the DME64N/24N is controlled from a DAW controller. This is set for
each zone configuration. The setting can be made only when in offline status.
Names and Functions
 [DME]
From the list, select the DME64N/24N where you will be making settings.
 [DAW Type]
Select the DAW type. The available settings are: MIDI, DAW(Type1), and DAW(Type2).
The [DAW Type] parameter has the same function as Protocol in the “Utility” dialog box MIDI tab.
MIDI: Use this setting when any MIDI device other than a general purpose ProTools controller (HUI
protocol) or general-purpose Logic or Cubase controller (Mackie control protocol) is to be connected.
DAW (Type1): Use this setting when a general purpose ProTools controller (HUI protocol) is to be
connected.
DAW (Type2): Use this setting when a general purpose Logic or Cubase controller (Mackie control
protocol) is to be connected.
 DAW Control Table
The following can be set for each channel from 1 to 64: [Function], [Controller], [Label], [Parameter].
NOTE
DAW Control can be set on DME64N/24N units only.
NOTE
DAW control editing can be performed only by users for whom the [Edit] security checkbox has been checked.