User Manual

Chapter 3 Main Panel Window
DME Designer Owner’s Manual
139
Remote Control Setup List
When you click the [Remote Control Setup List] command on the [Tools] menu, the “Remote Control
Setup List” dialog box is displayed.
Registers the parameters to be controlled from an external controller.
Names and Functions
[DME]
From the list, select the DME where you will be making settings.
[Function]
Select [No Assign], [Parameter Value Edit] or [Level Meter].
[Parameter]
Specifies the parameter to be controlled. A list of parameters will be displayed according to the
selection of [Function].
NOTE
DME V3.8 or later/DME Satellite units allow remote control via the [NETWORK] connector as well as via the [REMOTE]
connector. The port to be used is specified via the “Remote” tab of the “Utility” dialog box (page 172).
NOTE
For details about the communication protocol, refer to the “DME Remote Control Protocol Specifications” on the Yamaha Pro
Audio website (URL below).
http://www.yamahaproaudio.com/
NOTE
Does not apply to SP2060 units.
NOTE
Components for user modules are also listed in a hierarchal display, but if user module security is enabled, the
components are not displayed. However, parameters displayed in the user module editor are displayed here.