User Manual

Chapter 3 Main Panel Window
DME Designer Owner’s Manual
155
Communication Port Setup
Click the [Communication Port] item in the [Setup] menu to open the “Communication Port” dialog
box. In this window you can set the communication port of the master current device to be used by the
DME Designer.
“Communication Port” Dialog Box
[Tx]
Selects the driver communication port to be used for transmission.
[Rx]
Selects the driver communication port to be used for reception.
[Group]
Select the device group to be set up from the list.
NOTE
Selects either the USB-MIDI Driver or DME-N Network Driver for the communication port. Refer to the “DME Setup Manual”
for driver installation and setup instructions.
NOTE
Only USB x-1 can be selected for a DME Satellite unit connected via USB.