User Manual

Chapter 3 Main Panel Window
DME Designer Owner’s Manual
174
 MIDI Tab
Port
Selects the MIDI port to be used. If the selected terminal was previously assigned to a different
function, a confirmation dialog will appear. The available ports depend on the device.
DME64N: OFF, Remote(RS-232C), Remote(RS-422), MIDI, USB-1–2, Slot1–4
DME24N: OFF, Remote(RS-232C) , Remote(RS-422), MIDI, USB-1–2, Slot1
DME Satellite: OFF, Remote, USB-2
OFF: Select “OFF” when this function is not to be used.
Remote(232C): MIDI data will be received via the DME64N/24’s [REMOTE] connector using an
RS-232C connection.
Remote(422): MIDI data will be received via the DME64N/24’s [REMOTE] connector using an
RS-422 connection.
MIDI: The MIDI connector is the currently active MIDI port.
USB-1, USB-2: The corresponding USB port is selected for MIDI input.
Slot1–Slot4: A card installed in the corresponding I/O slot is currently selected for MIDI input.
Remote: The [REMOTE] connector of the DME Satellite is currently active MIDI port.
NOTE
When “Remote” is selected for a DME Satellite unit, be sure to change the [REMOTE] connector setting (RS-232C or
RS422) via the rear-panel DIP switches.