User Manual

Chapter 4 Designer
DME Designer Owner’s Manual
208
 [Configuration Manager]
Displays the “Configuration Manager” dialog box. Here you can add, delete, or rename a
configuration.
 See “Adding, Deleting, and Renaming a Configuration” on page 295.
 [Save User Module]
This command can be used only when a User Module is selected in the Configuration window.
Saves a template for the selected user module.
 “User Module Manager” Dialog Box in “User Modules” (page 310)
 [User Module Manager]
Displays the “User Module Manager” dialog box. Changes the settings of, renames, or deletes a
user module saved as a template.
 “User Module Manager” Dialog Box in “User Modules” (page 314)
 [Show Signal Delay]
The digital signal delay value is displayed in the configuration window with sample units.
 “Show Signal Delay (Delay Display Value)” in “Configuration Window” (page 305)
 [Analyze]
Displays the “Analyze” dialog box, and analyzes the configuration.
 “Analyze (Configuration Analysis)” in “Configuration Window” (page 308)
 [Probe Monitor]
Turns the probe monitor ON or OFF. This command can be selected only when a Configuration
window or User Module window is active while in online status.
 “Probe Monitor” in “Configuration Window” (page 303)
 [Monitoring Point List]
Opens the “Monitoring Point List” dialog box. Registers points for monitoring with headphones.
 “Monitoring Point List” in “Configuration Window” (page 306)
 [Edit Mode]
Turns the edit mode ON or OFF.
 “Edit Mode” in “Editing Configurations” (page 192)
 [Sheet]
Opens the “Sheet Settings” dialog box. Sets the sheet size and background.
 “Sheet” in “Objects” (page 262)
 [Prohibit Diagonal Connections]
All connections will be drawn with horizontal and vertical wires only. Diagonal wires cannot be
drawn.
 “Drawing Settings” in “Drawing and Editing Wires” (page 282)
 [Grid]
Opens the “Grid” dialog box. Displays or hides the grid and sets the grid spacing.
 “Grid” in “Design Window Shared Settings and Operations” (page 270)
NOTE
Only users for whom the [Operation Security]  [Edit] checkbox in the “Security” dialog box has been checked can
select this command.