User Manual

Chapter 6 Component Guide
DME Designer Owner’s Manual
398
 Compressor
When you click the [Compressor] button for the crossover processor, it opens the compressor
editor window. Here you can make compressor settings for each frequency band.
Name Function
1
Compressor Curve Displays results graphically. The horizontal axis is the
input signal level, and the vertical axis is the output
level.
2
Gain Reduction Meter Displays the gain reduction attenuation.
3
Output Meter Displays the output signal level.
Parameter Setting Range Function
4
Threshold -54 dB to ±0 dB Sets the threshold value.
5
Ratio 1:1 to ∞:1 Sets the compression ratio.
6
Knee HARD, 1, 2, 3, 4, 5 Sets the way compression is applied.
7
Attack 0 to 120 ms Sets the attack time.
8
Release 44.1 kHz: 6 ms to 46 s
48 kHz: 5 ms to 42.3 s
88.2 kHz: 3 ms to 23 s
96 kHz: 3 ms to 21.1 s
Sets the release time.
The setting range may vary, depending on the
operating frequency.
9
Gain ±0 dB to +18 dB Sets the output gain.
)
On ON/OFF Turns the compressor ON. When you turn this button
OFF, the compressor is bypassed.
1
23
)
4 5
6
7 8 9