User Manual

Chapter 6 Component Guide
DME Designer Owner’s Manual
423
Notch Filter (Notch)
The notch filter attenuates the signal within a specified frequency band, while passing frequencies
outside that band. There are two types of notch filter components: mono channel and stereo channel.
Mono channel notch filters have one input and one output. Stereo channel notch filters have two of
each.
Double-click a component to display the component editor for it. The parameters are the same for
mono channel and stereo channel components.
Section Parameter Setting Range Function
1
Input Level -∞ to +10 dB Sets the input signal level.
2
Phase ON/OFF Reverses the phase of the input signal.
3
Notch Frequency 20 Hz to 20 kHz Sets the center frequency.
4
Q: 0.1 to 63.0 Sets the band width of the frequency band
that will be changed
5
Bypass ON/OFF Turns bypass ON.
6
Output Level -∞ to ±0 dB Sets the output signal level.
2
1
5
3
4
6
Notch component editor