User Manual

Chapter 6 Component Guide
DME Designer Owner’s Manual
451
Double-click the component to open the component editor. The component editor is the same for the
16-input and 24-input types, the only difference being the number of channels. The Simple Mixer
component editor is organized into input channel and master output sections.
Section Parameter Setting Range Function
1
Input Channel EQ Details Opens the EQ editor window.
2
High Gain -18.0 to +18.0 dB Sets the gain of the EQ High band.
3
Mid Gain -18.0 to +18.0 dB Sets the gain of the EQ Mid band.
4
Low Gain -18.0 to +18.0 dB Sets the gain of the EQ Low band.
5
AUX1 Send -∞ to +10.0 dB Sets the AUX1 send level.
6
AUX2 Send -∞ to +10.0 dB Sets the AUX2 send level.
7
AUX1 Send Point Pre/Post Switches the AUX1 send point to pre-
fader (Pre) or post-fader (Post).
8
AUX2 Send Point Pre/Post Switches the AUX2 send point to pre-
fader (Pre) or post-fader (Post).
9
Pan L63 – Center – R63 Sets the pan position.
)
Pair ON/OFF Engages paired operation for odd
and even channel pairs. (excluding
Pan, PFL, and AUX Send operation).
When turned ON the odd-channel
parameters are copied to the even
channel. When ON Pan functions in
LR Nominal mode (nominal level
when pan is full left or right) and when
OFF Pan functions in Center Nominal
mode (nominal level when pan is
center).
!
On ON/OFF Turns the input of each channel ON.
@
Fader -∞ to +10.0 dB Sets the input level for each input
channel.
1
2
4
5
6
9
!
@
#
3
7
8
$
%
^
&
*
)