User Manual

Chapter 6 Component Guide
DME Designer Owner’s Manual
460
Room Combiner
The Room Combiner component is for use in facilities where movable partitions allow rooms to be
divided or combined. The audio feeds can be easily adjusted to match the physical room
configuration.
For example, if Room 1 and Room 2 are to be combined to create a single large room, the audio feed
for Room 1 can be connected to IN 1 of the component, and the audio feed for Room 2 can be
connected to IN 2 of the component. Then when “Combine” for Room 1 and Room 2 is “ON,” the audio
signals connected to IN 1 and IN 2 are summed and output via OUT 1 and OUT 2. When “Combine”
for Room 1 and Room 2 is “OFF,” the IN 1 signal is sent to OUT 1 only, and the IN 2 signal is sent to
OUT 2 only.
Components are available for combining up to 4, 8, 12, or 16 rooms.
Double-click the component to open the component editor. The component editor is the same for all
types, the only difference being the number of rooms.
*1 Depends on the number of rooms provided by the placed component.
Parameter Setting Range Function
1
Combine ON/OFF Specifies whether the rooms are to be combined or not.
2
Room No. *1 Specifies the room number to be combined. “Room
No.” refers to the numbers that are the component’s
input port names.
12