User Manual

Chapter 6 Component Guide

DME Designer Owner’s Manual

492

Analog Input and Output

In the DME24N/DME Satellite configuration window, there are [Analog Input] and [Analog Output]

blocks.

 Analog Input

Right-click the component and select [Open HA Editor] from the contextual menu to open the

editor.

Either double-click the component, or select [Open Input Component Editor] from the contextual menu

that appears when the component is right-clicked to open the component editor.

Caution

• If you don’t need phantom power, be sure to turn this button off.

• Before you turn phantom power on, make sure that no equipment other than phantom-powered devices

such as condenser microphones are connected to that jack. Otherwise, you risk damaging your external

equipment. Balanced dynamic microphones, however, will not be affected by phantom power.

• Do not connect or disconnect a device to [IN]/[INPUT] jacks while phantom power is applied. Doing so

can damage the connected device and/or the unit itself.

• To protect your speaker system, leave the power amps (powered speakers) turned off when switching the

phantom power on/off. We also recommend that you set all output levels to minimum. Otherwise, high-

volume output may damage your hearing or equipment.

NOTE

The DME24N, DME8i-C, DME4io-C, DME8i-ES and DME4io-ES have analog inputs. The DME24N, DME8i-C and DME8i-ES

have eight analog inputs, while the DME4io-C and DME4io-ES have four.

Parameter Setting Range Function

+48 ON/OFF Turns ON phantom power (+48V).

Gain +10 to -60 dBu Sets the rated input level.