User Manual

Chapter 3 Main Panel Window
DME Designer Owner’s Manual
84
Configuration
Displays the configuration name. If the scene has not been stored, a hyphen (-) will be displayed.
Edit Security
Displays the scene edit security levels. Clicking here will display a list where you can change these
security levels. Only levels at or below the security level of the currently logged on user are
displayed in the list. Scenes are stored with the same security level as the user, but their store and
edit security levels can be set lower if required.
Recall Security
Displays the scene recall security level. Clicking here will display a list where you can change the
security level. Only levels at or below the security level of the currently logged on user are
displayed in the list. Scenes are stored with the same security level as the user, but their recall
security levels can be set lower if required.
Fade
It sets whether fade is applied (ON) or not (OFF) when a scene is recalled.
When “ON” the faders in fader components will “fade” to their new settings according to the
specified fade mode and fade time when a scene is recalled. This only applies to fader
components.
Fade Mode
Sets the fade mode. You can select “All” or “Selected.”
If you select “All,” all channels using Fader components in their configuration will be affected. Even
when multiple components are used, all channels are targeted. If you select “Selected,” the only
channels affected will be those for which the Fade switch in the component editor has been set to
ON.
NOTE
The fade function cannot be simulated in DME Designer.
NOTE
The Fade switch for each channel is set to OFF by default. The fade effect will not be applied, even if Fade=ON and
Fade Mode=Selected is selected. To apply the effect, you must set the Fade switch to ON for the channels where you
need it.