User Manual

Advanced Setup
DME Setup Manual 17
4 Click [Properties] on the [General] tab.
The “Local Area Connection Properties” dialog
box will be displayed.
5 Select [Internet Protocol (TCP/IP)] on the
[General] tab, then click [Properties].
The “Internet Protocol (TCP/IP) Properties”
dialog box will be displayed.
6 Click [Detailed Settings], then in the
“TCP/IP Detailed Settings” dialog box
click [Properties] in the [Options] tab.
The “TCP/IP Filtering” dialog will be displayed.
7 Select “Permit All” for TCP Ports, then
click [OK].
The display returns to the “Advanced TCP/IP
Settings” dialog. Click [OK] to return to the
“Internet Protocol (TCP/IP) Properties” dialog.
n Consult the network administrator if settings need to
be changed.
8 Click [Use the Following IP Address].
9 Enter your computer’s IP address into
[IP address], the Gateway’s IP address
into [Default gateway], and
“255.255.255.0” into [Subnet mask].
n The network address must be set to that same
address as the DME devices, while the host
address must be set to a different value.
n Set the gateway IP host address to 254.
10 Click [OK].
n If the computer is being used in an office, for example,
and already has an assigned IP address, either the
current settings will have to be changed or the computer
will have to be connected to the DME unit via a USB
cable.

DME Network Connections
When the necessary settings have been made, connect the DME units and computer via a switching hub
using Ethernet cables, as shown in the example on page 13.
Network
Switch
Computer
DME4io-C
DME8o-C
DME64N
USB