User Manual

Chapter 6 Component Guide
DME Designer Owner’s Manual
403
■ Input Master
If you click the [Input Master] button in the delay matrix component editor, it will open the [Delay
Matrix - InputMaster] editor window. Here you can turn the master input for each channel ON and
OFF and set the level.
Section Parameter Setting Range Function
1 Input Phase ON/OFF Reverses the phase of each channel’s signal.
2 Level -∞ to +10 dB Sets the level of the signal from each channel’s
input.
3 Solo ON/OFF Turns ON solo for each channel. If Solo is engaged
for even one channel, all non-Solo channels will be
muted.
4 On ON/OFF Turns ON each channel’s input.
5 Block On -- Turns ON input for all channels in the Input Master
window. When turned ON, the [On] button lights up.
6 Off -- Turns OFF input for all channels in the Input Master
window.
7 Nominal -- Resets all input signal levels in the Input Master
window, making them 0 dB.
8 Minimum -- Resets all input signal levels in the Input Master
windows, making them -∞ dB.
Click to open the “In 1-4 x
Out 1-4” Crosspoint window.
Click to open the “In 5-8 x Out
5-8” Crosspoint window.
For 2 input matrix, click to
open the “In 1-2 x Out 1-4”
Crosspoint window.
5
6
8
7
2
1
3
4
[Delay Matrix - InputMaster] editor window