User Manual

Chapter 6 Component Guide
DME Designer Owner’s Manual
474
Display Setup (Disp) Page
Provides access to a number of display parameters.
1 LCD Contrast
The current LCD contrast setting. This parameter can
be adjusted from 0% through 100%.
Edit using the “Numeric Parameters” editing
procedure described on page 468.
2 LCD Backlight
Specifies LCD backlight operation. Two settings are
available: “ON,” and “OFF.”
ON: The display is continuously lit.
OFF: The display lights when a control is operated,
and will go out 10 seconds after panel operation
ceases.
Edit using the “List Parameters” editing procedure
described on page 469.
Security Setup (Lock) Page
Panel lock and related settings.
1 Utility
The lock status for the Utility display settings. This
parameter can be set to “Unlock” or “Lock.”
Unlock: The Utility display can be accessed without
a password.
Lock: A password must be entered to access the
Utility display.
When “Lock” is selected a password entry window will
appear when the [F4/UTILITY] key is pressed to
access the utility pages.
Use the [F1] and [F3] buttons to position the cursor,
and the dial to enter the desired character at the
cursor location. When all of the password’s characters
have been entered as required press the [ENTER]
key.
The password will also be required when switching
from the “Unlock” mode to the “Lock” mode.
NOTE
The MAC address is also known as the Ethernet address,
and is an independent address assigned to all Ethernet
devices. No two devices anywhere in the world can have
the same address.
1
2
NOTE
Password security and management is very important!
If you forget your password the unit cannot be operated!
If you forget your password contact the system
administrator.
If the password become unrecoverable for some reason
and you need to unlock the system, please contact your
Yamaha representative.
1
2
3
4