User Manual

Chapter 3 Main Panel Window

DME Designer Owner’s Manual

■ [Group] List

Allows selection of a device group to be synchronized.

■ [Go On-line] Button

This button will be grayed out when the software is online.

Clicking the button displays a dialog box where you can decide the synchronization method.

[Designer→DME] button

A consistency check is performed between the data in the current device group and the DME or

SP2060 data, then the communication status changes to online. Transmits data from the DME

Designer to the DME or SP2060 unit and synchronizes the two.

[Designer←DME] button

Data from the DME or SP2060 unit is read into DME Designer. Current data stored in the DME or

SP2060 unit, such as scenes, are read into DME Designer. The conﬁgurations in the DME unit and

DME Manager must identical to allow synchronization. Even if the basic conﬁgurations are the

same, if one has been edited or changed in any way synchronization will not be possible.

SP2060 conﬁgurations cannot be edited, so synchronization is always possible.

■ [Go Off-line] Button

Clicking this button changes from online to ofﬂine. While ofﬂine, this button will be grayed out.

■ [Close] Button

Closes the dialog box.

■ [Close this window after synchronization] Checkbox

When this checkbox is checked the dialog window will close automatically after synchronization.