User Manual

Chapter 6 Component Guide
DME Designer Owner’s Manual
458
■ Delay
Click the Speaker Processor [Delay] button to open the window. Delay can be set independently
for each output channel.
7 HPF Type Thru
6dB/Oct
12dB/Oct AdjustGc
12dB/Oct Butrwrth
12dB/Oct Bessel
12dB/Oct Linkwitz
18dB/Oct AdjustGc
18dB/Oct Butrwrth
18dB/Oct Bessel
24dB/Oct AdjustGc
24dB/Oct Butrwrth
24dB/Oct Bessel
24dB/Oct Linkwitz
36dB/Oct AdjustGc
36dB/Oct Butrwrth
36dB/Oct Bessel
48dB/Oct AdjustGc
48dB/Oct Butrwrth
48dB/Oct Bessel
48dB/Oct Linkwitz
Sets the roll-off slope and filter type for each
octave.
The filter is bypassed when [Thru] is
selected.
8 Frequency 20 Hz to 20 kHz Sets the HPF cutoff frequency.
9 Gc -6 dB to +6 dB Sets the cutoff frequency gain when the
[Type] setting is [AdjustGc] (Adjustable Gc).
Parameter Range Function
1 Delay ms: 0 to 500
Sample: the range
depends on the Fs value.
Meter: 0 to 171.8
Feet: 0 to 563.6
Frame: the range depends
on the Frame value.
Beat: the range depends
on the Beat value.
Sets the delay time.
Two edit boxes show milliseconds and the unit
specified in the [Delay Scale] section.
Sets the output level for each band.
2 On ON/OFF Turns delay ON.
3 Delay Scale ms
Sample
Meter
Feet
Frame
Beat
Selects the delay time units. The selected button will
light and the [Delay] edit box will change accordingly.
When [Beat] is selected the knobs can be used to
adjust BPM.
NOTE
Delay Scale does not support the parameter link feature. Refer to “Parameter Link” on page 90 for information on parameter
linking.
Section Parameter Range Function
3
2
1
[Speaker Processor - Delay] editor window