User Manual

Appendix
DME Designer Owner’s Manual
503
2 Panel Lock Boot
Determines whether or not panel lock will be on when
power to the device is turned on. This parameter can
be set to “Unlock” or “Lock.”
Unlock: Panel lock is OFF when power to the
device is turned on.
Lock: Panel lock is ON when power to the device is
turned on.
3 Panel Lock Target
Displays the controls (control functions) to be affected
by panel lock. Panel Lock Target status of ICP1 is fix
to “Key Only.”
4 User Defined Lock
Sets the lock status individually for each of the four
User Defined Button pages.
ON: The corresponding User Defined Button will
not appear on the display.
OFF: The corresponding User Defined Button will
appear on the display.
To change the settings use the [F1] and [F3] keys to
move the cursor to the setting for the desired page,
the press the [ENTER] button to alternately turn the
setting “ON” and “OFF.”
Miscellaneous Setup (Misc)
Page
This page includes parameters not available in any
other page.
1 Scene Store
Determines whether or not scene store operations are
allowed. This parameter can be set to “Enable” or
“Disable.”
Enable: Scene store operations are allowed.
Disable: Scene store operations are prohibited.
Edit using the “List Parameters” editing procedure
described on page 497.
2 Last Mem. Resume
This parameter displays whether the ICP1 will recall
the current scene when started up, or whether the
memory contents at the time the unit was turned off
will be recalled.
ON: The memory contents at the time the unit was
turned off will be recalled at startup.
OFF: The current scene will be recalled at startup.
The Last Men. Resume status can not be changed
from ICP1 controls.
3 Event Scheduler
Displays the current status of an event schedule setup
in the DME Designer will be executed or not.
ON: The event will be executed.
OFF: The event schedule will not be executed.
Edit using the “List Parameters” editing procedure
described on page 497.
NOTE
See page 495 for details on how to use the Panel lock
feature.
NOTE
The User Defined Button are accessed as described in
the “Parameter Edit Display” section on page 496.
NOTE
See page 499 for scene store procedure.
NOTE
This setting applies to individual devices only. Even if one
ICP1 unit is set to “Disable,” scene store operations will be
possible via another DME series in the same device group
that is set to “Enable.”
NOTE
The event schedule status can not be changed from the ICP1
controls.
1
2
3