User Manual

Chapter 3 Main Panel Window

DME Designer Owner’s Manual

“Synchronization” Dialog Box

When you click the [Synchronization] command on the [Tools] menu, the “Synchronization” dialog box

is displayed. The data from the current device group in the Designer is synchronized with the DME or

SP2060 unit.

Here you can make settings for synchronizing the unit in DME Designer one-on-one with the DME or

SP2060 that actually exists on the network.

Names and Functions

■ [Group] List

Allows selection of a device group to be synchronized.

NOTE

When synchronization is executed the connections, components, and other data are automatically checked as part of the

compilation process. A progress bar will appear during compilation, but in some cases it may not exactly match the

progress of the compilation process. Also, the appearance of the progress bar is no guarantee that compilation will be

completed successfully. If compilation continues for an inordinately long period of time, click the [Abort] button to stop

processing. Try eliminating unnecessary components and connections, and replacing components that place a heavy load

on resources with more efﬁcient ones, then compile again.

NOTE

Once a conﬁguration has been analyzed or compiled successfully, subsequent analysis or compilation will run quicker

unless changes are made to the conﬁguration. Also, if you save the project ﬁle the analysis/compilation data is saved as

well.

[Go On-line]Button [Go Off-line]Button

[Designer]

Message Area

[Close This window

after synchronization]

checkbox

[Store Project File into DME

after synchronization]

checkbox

[Network]