Owner`s manual

29
English
Switching the IMPEDANCE SELECTOR switch on the
rear panel
Select the position whose requirements your speaker system
meets. Be sure to switch this only when the power of this unit is
turned off.
WARNING
Never switch the setting of this switch when the power of
this unit is on, otherwise this unit will break down.
(Upper position)
Center: If you use one center speaker, the impedance of the
speaker must be 4Ω or higher.
If you use two center speakers, the impedance of each
speaker must be 4Ω or higher.
Rear: The impedance of each speaker must be 4Ω or higher.
Main: If you use one pair of main speakers, the impedance of
each speaker must be 4Ω or higher.
If you use two pairs of main speakers, the impedance of
each speaker must be 8Ω or higher.
Front effect:
The impedance of each speaker must be 6Ω or higher.
(Lower position)
Center: If you use one center speaker, the impedance of the
speaker must be 8Ω or higher.
If you use two center speakers, the impedance of each
speaker must be 4Ω or higher.
Rear: The impedance of each speaker must be 8Ω or higher.
Main: If you use one pair of main speakers, the impedance of
each speaker must be 8Ω or higher.
If you use two pairs of main speakers, the impedance of
each speaker must be 16Ω or higher.
Front effect:
The impedance of each speaker must be 8Ω or higher.
(Europe model)
IMPEDANCE SELECTOR
CENTER C OR D: 4 Ω MIN./ SPEAKER
SET SPEAKER MODE
C D: 4 Ω MIN./ SPEAKER
SET SPEAKER MODE
REAR 4 Ω MIN./ SPEAKER
MAIN
A OR B: 4 Ω MIN./ SPEAKER
A B : 8 Ω MIN./ SPEAKER
FRONT EFFECT : 6 Ω MIN./ SPEAKER
CENTER C OR D: 8 Ω MIN./ SPEAKER
SET SPEAKER MODE
C D: 4 Ω MIN./ SPEAKER
SET SPEAKER MODE
REAR 8 Ω MIN./ SPEAKER
MAIN
A OR B: 8 Ω MIN./ SPEAKER
A B : 6 Ω MIN./ SPEAKER
FRONT EFFECT : 8 Ω MIN./ SPEAKER