Owner's Manual

CONNECTING THE EFFECT SPEAKERS TO THIS
UNIT
Connect the FRONT effect speakers to the FRONT effect
speaker output terminals of this unit.
If the FRONT effect speakers are not used, the FRONT MIX
switch should be set to “ON”.
Connect the REAR effect speakers to the REAR effect speaker
output terminals of this unit.
Connect the CENTER speaker to the CENTER speaker output
terminals. If you will be using one CENTER speaker, connect it to
either the A or B terminals and set the CENTER speaker impedance
switch to “A or B” (bottom position). If using two CENTER speakers,
connect them to the A and B terminals, and set the switch to “A + B”
(top position). If, however, you will not be using a CENTER speaker,
be sure to set the Center Mode to “PHNTM” (phantom). (See page
25.)
NOTE: The speaker connections above are fine for most
applications. If for some reason, however, you wish to use an
external power amp for any or all of the effect channels, connect the
line level output jack(s) for each channel to the INPUT jacks of the
external amp and connect the corresponding speaker pair to the
speaker terminals of the external amp.
NOTE: If the pin plug is inserted in the FRONT/REAR EFFECT out
jacks, the speaker output from the built-in amplifier will be cut off.
17
LR
LR
Front effect
speaker
Rear effect
speaker
Front effect
speaker
Rear effect
speaker
This unit
Center speaker Center speaker
Center speaker