Owner`s manual

1
Set to the “
∞
” position.
2
Turn the power on.
3
Select a source using the input selector on the
integrated amplifier etc.
* To select a tape deck connected to this unit’s TAPE
terminals, press the TAPE MONITOR switch so that “TAPE
MONITOR” lights up on the display. (Otherwise, press this
switch to turn it off.)
Note
If this unit is connected to the TAPE REC OUT terminals of
the integrated amplifier etc., the following operations are
needed.
• If your amplifier has the REC OUT selector which is
independent of the input selector;
1. Set the input selector to the position (AUX, TAPE, etc.)
which corresponds to the amplifier’s terminals
connected to this unit’s FRONT OUT terminals.
2. Select the source to be input to this unit using the REC
OUT selector.
• If your amplifier does not have the REC OUT selector
which is independent of the input selector;
1. Set the TAPE monitor switch on the amplifier to on.
2. Select the source to be input to this unit using the input
selector.
4
Play the source.
5 Turn the DSP on, so that a DSP program name
appears on the display.
6
Select a desired program suitable for the source.
The corresponding indicator will light up.
7
Adjust to the desired output level.
8 If desired, adjust the delay time and the output level of
each speaker. (For details, refer to the corresponding
descriptions on page 14 and 15.)
13
To play a source with the digital sound field processor
PROGRAM
PRO LOGIC
POWER
EFFECT
CONCERT
HALL
TEST
MASTER
VOLUME
TAPE MONITOR
PRO LOGIC ENHANCED
HALL
CNCT VIDEO
EFFECT
ON/OFF
+
–
PROGRAM
—
MONO MOVIE
CENTER MODE
+
–
DELAY
TIME
ROCK
SUR.
6
7
5
3
8
TAPE
MONITOR
TAPE
MONITOR
26
85
31,7