Owner`s manual

14
To obtain the best performance of this unit:
If the connecting method of your components is A or C
shown on pages 6–7, set the volume control on the integrated
amplifier or control amplifier to about the halfway position
between the min. and max.
Notes
●
If you prefer to cancel the DSP, press the EFFECT switch.
The sound will be the normal 2-channel stereo without
surround sound effect.
●
When CONCERT VIDEO, MONO MOVIE, ROCK
CONCERT or CONCERT HALL is selected, no sound is
heard from the center speaker.
●
When a monaural sound source is played with DOLBY
PRO LOGIC or DOLBY PRO LOGIC ENHANCED, no
sound is heard from the front speakers and the rear
speakers. Sound is heard only from the center speaker.
However, if the center channel mode is in PHANTOM, the
front speakers output the sound of the center channel.
●
When this unit’s Dolby Pro Logic Surround system is used,
if the main-source sound is considerably altered by
overadjustment of the BASS or TREBLE controls on the
integrated amplifier etc., the relationship between the center
and rear channels may produce an unnatural effect.
●
If the connected external amplifier has a built-in surround
sound or ambience circuitry, be sure that the surround or
ambience circuitry on that amplifier is off while you are
using this unit’s Dolby Pro Logic Surround system.
If desired, you can adjust the sound output level of the center
speaker even if the output level is already set in “SPEAKER
BALANCE ADJUSTMENT” on page 11.
●
If the digital sound field program CONCERT VIDEO, MONO
MOVIE, ROCK CONCERT or CONCERT HALL is selected,
this adjustment is useless.
●
Once the output level is adjusted, the level value will be the
same in the DOLBY PRO LOGIC and DOLBY PRO LOGIC
ENHANCED programs.
●
If no program is used, this adjustment is useless.
Adjustment of the CENTER LEVEL
Adjustment of the REAR LEVEL
If desired, you can adjust the sound output level of the rear
speakers even if the output level is already set in “SPEAKER
BALANCE ADJUSTMENT” on page 11.
●
Once the output level is adjusted, the level value will be the
same in all the digital sound field programs.
●
If no program is used, this adjustment is useless.
CENTER LEVEL
0I0
REAR LEVEL
0I0