Operation Manual

CONNECTING SPEAKER SYSTEMS
Connect the SPEAKERS terminals to your speakers with wire of
the proper gauge, cut as short as possible. If the connections are
faulty, no sound will be heard from the speakers. Make sure that the
polarity of the speaker wires is correct, that is, + and – markings are
observed. If these wires are reversed, the sound will be unnatural
and will lack bass. Do not let the bare speaker wires touch each
other or any other metal part as this could damage this unit and/or
speakers.
NOTE: Use speakers with the specified impedance shown on the
rear of this unit.
Red: positive (+)
Black: negative (–)
➀ Press down the tab.
➁ Insert the bare wire.
[Remove approx. 5mm (1/4”)
insulation from the speaker
wires.]
➂ Press up the tab and secure
the wire.
CONNECTING THE REAR EFFECT SPEAKERS TO
THIS UNIT
Connect the REAR effect speakers to the REAR SPEAKERS
terminals of this unit.
NOTE: If for some reason, you wish to use an external power amp
for the rear effect channel, connect the REAR OUTPUT jacks to the
INPUT jacks of the external amp and connect the rear effect speaker
pair to the speaker terminals of the external amp.
15
SINGLE
DUALDUAL
SINGLE
AB
Rear Effect
Speaker
R
Rear Effect
Speaker
L
➀
➁
➂