Operation Manual

1 Power Switch

* STANDBY Mode (Europe model only)

While the power is on, pressing the POWER key on the remote

control unit switches the unit to the STANDBY mode. (In this

mode, the indicator is half illuminated.)

2 Remote control sensor

Signals from the remote control unit are received here.

3 Display Panel

Shows program names, parameters and information about other

various settings and adjustments.

4 PRO LOGIC Indicator

Illuminates while the built-in Dolby Pro Logic Surround Decoder is

being activated.

5 DSP Indicator

Illuminates while the built-in Sound Field Processor is being

activated.

6 Program Selector

Sequentially selects the digital sound field processing

programs in the + or – direction.

7 Effect Switch

Normally ON, this switch can be turned OFF to disable output

from the center and effect speakers so that the sound

becomes normal 2-channel stereo.

8 Tape Monitor Switch

Used when you have connected the tape deck to this unit’s

TAPE terminals to select that tape as the source. (See page 12

and 24.)

9 Master Volume Control

Simultaneously controls signal level at all outputs: main, rear

effect, center, and subwoofer. (This does not affect TAPE REC

OUT level.)