Owner's Manual

111 En
Using multi-zone configuration
ADVANCED
OPERATION
• When you use the external amplifiers in Zone 2 or Zone 3,
J
VOLUME +/– can be used only when “Zone2 Volume” or
“Zone3 Volume” is set to “Variable” (page 86).
• You cannot adjust the volume level of Zone 4 with the controls
on this unit. Use controls on the Zone 4 component to adjust it.
■ Adjusting the front speaker balance of
Zone 2 or Zone 3
Press DTONE CONTROL repeatedly to select
“BALANCE” and then rotate the JPROGRAM
selector for adjustment.
■ Adjusting the tonal quality of Zone 2 or
Zone 3
You cannot adjust the front speaker balance of Zone 4 with the
controls on this unit. Use controls on the Zone 4 component to
adjust it.
Press DTONE CONTROL repeatedly to select
the high-frequency response (TREBLE) or the
low-frequency response (BASS) and then rotate
the JPROGRAM selector for adjustment.
Control range: –10.0 dB to +10.0 dB
■ Setting the sleep timer for Zone 2, Zone
3 or Zone 4
Use this feature to turn of the desired zone after a certain
amount of time.
Set the operation mode to FAMP and then press
CSLEEP repeatedly to set the amount of time.
The sleep timer setting changes as shown below.
■ Using the zone OSD
You can browse music contents (such as iPod contents) by
using the zone OSD.
1 Set the operation mode selector to FAMP
and then press the desired input selector
button (3).
2 Press KDISPLAY to display the menu
screen on the zone OSD.
3 Use 9k / n / l / h and 9ENTER to
navigate the menu on the zone OSD.
• The menu displayed in the zone OSD appears in English
even if Japanese or Russian is selected.
• There are some characters that cannot be displayed in the
front panel display or in the OSD of this unit. Those
characters are replaced with underscores “_”.
y
• You can select the zone(s) of which the operational status
is displayed (page 87).
• You can operate the zone OSD in the same way as GUI
operations.
Notes
Note
120min. 90min.
60min.30min.OFF
Notes