Owner's Manual

114 En
Advanced setup
■ Remote control ID setting
REMOTE CON AMP
Use this feature to set the remote control ID of this unit for
remote control recognition.
Setting remote control ID
Use this feature to set the remote control ID. This feature
is useful when you control multiple Yamaha AV receiver
or amplifier with using the remote control.
Press GID repeatedly using a ballpoint pen or
similar object on the remote control to select the
desired remote control ID.
Each time you press GID, the remote control ID indicator
changes as shown below.
y
To set the remote control ID of the simplified remote control,
see page 106 for details.
■ Bi-amplifier mode BI-AMP
Use this feature to activate or deactivate the bi-amplifier
function.
When “BI-AMP” is set to “ON”, the SURROUND BACK
terminals cannot be used to connect surround back speakers in
that the terminals are already used for the bi-amplifier
connection (page 19) and the presence speaker output is
disabled.
■ Pre-amplifier mode PREAMP MODE
Use this feature to select whether you use this unit as the
preamplifier in the main zone.
y
This setting does not affect the amplifier assignments for the
other zones (SP1 and SP2).
■ Recovery and backup of the system
settings
RECOV./BACKUP
Use this feature to save and restore the settings of this unit.
• This unit does not save the preset USB/network items, and
system memory settings.
• If no settings are saved, you cannot select “RECOVERY”.
■ Parameter initialization INITIALIZE
Use this feature to reset the parameters of this unit to the
initial factory settings. You can select the category of
parameters to be initialized.
y
To initialize the parameters of each sound field program, use
“Initialize” in “Stereo/Surround” (page 72).
■ MAC address filter MAC FILTER
Use this feature to filter the access to this unit via LAN to
control this unit by the MAC address of the accessing PC
(page 95).
y
You can register the MAC address that is allowed to access
when “MAC FILTER” is set to “ON” by using the Web browser
(page 95).
Choice Descriptions
ID1
Select this setting when the ID of the remote
control is set to “ID1”
ID2
Select this setting when the ID of the remote
control is set to “ID2”
Choice Descriptions
ON
Select this setting if you want to activate the bi-
amplifier function.
OFF
Select this setting if you want to deactivate the bi-
amplifier function.
Note
Choice Descriptions
ON
Select this setting when you use this unit as the
preamplifier in the main zone. The audio signals
for the main zone are only output at the PRE OUT
jacks of this unit.
OFF
Select this setting to use the internal amplifiers of
this unit for the main zone.
ID
ID1
ID2
Choice Descriptions
RECOVERY
Restoring the saved setting of this unit.
BACKUP
Saves the current settings of this unit.
CANCEL
Cancels the recovery or backup of the settings of
this unit.
Notes
Choice Descriptions
DSP
PARAM
Select this setting to initialize all the parameters of
the sound field parameters (page 68).
VIDEO
Select this setting to initialize all the parameters in
“Video” and “Display Set” (except “Short
Message” and “Playback Screen”).
NETWORK
Select this setting to initialize all the parameters in
“Network” and MusicCAST information stored in
this unit.
ALL
Select this setting to initialize all the parameters of
this unit.
CANCEL
Select this setting to cancel the initialization
procedure.
Choice Descriptions
ON
Only allows to accept the access from the PC
whose MAC address is registered to this unit.
OFF
Allows to accept the access from any PC.