Owner's Manual

75 En
Graphical user interface (GUI) menu
ADVANCED
OPERATION
Press 9ENTER to establish a connection.
The connected Bluetooth receiver starts searching
Bluetooth components. Once the connection is established
successfully, “BT Connected” appears.
If the connected Bluetooth receiver cannot find any Bluetooth
components, “Not found” appears.
y
To terminate the connection, press 9ENTER again.
■ USB Select (USB port select)
Selects the component connected to the front or rear USB
port as the input source (page 28).
Use this feature to browse the music contents of iPod,
USB component, PC/MusicCAST and Internet radio. See
the following pages for details.
• iPod (page 57)
•USB (page59)
• PC/MCX (page 59)
• NET RADIO (page 59)
Use this feature to manually adjust the basic speaker
settings. Most of the “Speaker” parameters are set
automatically when you run the automatic setup.
y
• Set “Test Tone” to “On” to output the test tone for the
“Configuration”, “Distance” and “Level” settings.
• If your subwoofer can adjust the output volume and the
crossover frequency, set the volume to about half way (or
slightly less) and set the crossover frequency to the maximum.
■ Configuration (Speaker configurations)
Front (Front speakers)
When “Bass Out” is set to “Front” (page 76), you can select
only “Large” in “Front”. If the value of “Front” is set to other
than “Large” in advance, this unit change the value to “Large”
automatically.
Center (Center speaker)
Surround (Surround left/right speakers)
Note
Choice Functions
Front
Selects the component connected to the front
USB port as the input source.
Rear
Selects the component connected to the rear
USB port as the input source.
Music Content
Setup (Speaker)
Measure for the speaker size
The woofer section of a speaker is
– 16 cm (6.5 in) or larger: large
– smaller than 16 cm (6.5 in): small
Choice Descriptions
Large
Select this setting when the front speakers
are large.
Small
Select this setting when the front speakers
are small.
Note
Choice Descriptions
Large
Select this setting when the center speaker is
large.
Small
Select this setting when the center speaker is
small.
None
Select this setting when you do not use the
center speaker. The center channel signals
are directed to the front left and right
speakers.
Choice Descriptions
Large
Select this setting when the surround
speakers are large.
Small
Select this setting when the surround
speakers are small.
None
Select this setting when you do not use the
surround speakers. This unit is set to the
Virtual CINEMA DSP mode (page 50), and
“Surround Back” is automatically set to
“None”.