Owner's Manual

83 En
Graphical user interface (GUI) menu
ADVANCED
OPERATION
1 Press
9
k / n repeatedly to select
“Adjustment” and then press
9
ENTER.
2 Press
9
l / h repeatedly to select a preset
number to which you want to save the video
quality adjustments and then press
9
ENTER.
y
To recall the preset video quality adjustments, press 9l /
h to select a preset number to recall, press 9ENTER
and then skip to step 8.
3 Press
9
n
to select “EDIT” and then press
9
ENTER
.
4 Press
9
l / h
repeatedly to select the video
quality parameter you want to adjust and then
press
9
n to move to the adjustment field.
5 Press
9
l / h repeatedly to adjust the
setting of the selected video quality
parameter.
6 To adjust another video quality parameter,
press
9
k / n repeatedly to select the
parameter field and then repeat steps 4 and 5.
7 Press
9
n to select “OK” and then press
9
ENTER.
y
To cancel the operation without change, press 9l / h
to select “CANCEL” and then press 9ENTER.
8 Press
9
k / n / l / h to select “CLOSE” and
then press
9
ENTER.
Mosquito NR (Mosquito noise reduction)
Mosquito noise is a type of noise that appears along
edges of compression artifacts. Use this feature to
adjust the mosquito noise reduction level.
Choices: Off, Low, Medium, High
Block NR (Block noise reduction)
Block noise is often caused when the bitrate is too
low to accurately encode the video. Use this feature
to adjust the block noise reduction level.
Control range: 0 to 50
Detail Enhancement (Detail enhancement)
Use this feature to adjust finesses of images.
Control range: 0 to 50
Edge Enhancement (Edge enhancement)
Use this feature to adjust sharpness of images.
Control range: 0 to 50
Brightness (Brightness)
Use this feature to adjust brightness of images.
Control range: –50 to 50
Initial setting: 0
Contrast (Contrast)
Use this feature to adjust contrast of images.
Control range: –50 to 50
Initial setting: 0
Saturation (Saturation)
Use this feature to adjust saturation of images.
Control range: –50 to 50
Initial setting: 0
Use this feature to set the HDMI functions or check the
information about the video monitors connected to the
HDMI OUT jacks.
■ Standby Through (Standby through)
Mode (Standby through mode)
Use this feature whether this unit allows the HDMI signals
input at the HDMI IN jacks to pass thorough this unit
when this unit is in the standby mode. You can also
designate an HDMI IN jack and HDMI OUT jack(s) that
accept the signals when “Mode” is set to “Fix” and this
unit is in the standby mode.
Preset Select
123456
EDIT CLOSE
1 Mosquito NR
Off
OK CANCEL
Video quality parameter
Adjustment
Setup (HDMI)
Choice Functions
Off
Disables the HDMI standby through feature.
HDMI signals do not pass through this unit if
this unit is in the standby mode.
Last
HDMI signals pass through this unit (only from
the HDMI IN jack to the HDMI OUT jack(s)
used when this unit is set to the standby mode)
even when this unit is in the standby mode.