Owner's Manual

85 En
Graphical user interface (GUI) menu
ADVANCED
OPERATION
Subnet Mask (Subnet mask)
Use this parameter to specify the subnet mask value
assigned to this unit.
y
For most of the cases, the subnet mask value can be set as
“255.255.255.0”.
Default Gateway (Default gateway)
Use this parameter to specify the IP address of the default
gateway.
DNS Server (P) (Primary DNS server)
DNS Server (S) (Secondary DNS server)
Use this parameter to specify the IP address of the primary
and secondary DNS (Domain Name System) servers.
If you have only one DNS address, enter the DNS address in
“DNS Server (P)”. If you have two or more DNS addresses,
enter one of them in “DNS Server (P)” and another in “DNS
Server (S)”.
■ Network Standby (Network standby)
Use this feature to select whether this unit accepts the
commands via LAN network when this unit is in the
standby mode.
When “Network Standby” is set to “On”, the amount of power
consumption in the standby mode increases.
■ Information (Network information)
Use this feature to display the network system
information.
MAC Address
(MAC (Media Access Control) address)
This information displays the MAC address that is
assigned to this unit.
Status (Network status)
This information displays the current link status of the
network.
Display status: 10BASE-T, 100BASE-TX, No Link,
Full Duplex, Half Duplex
“No Link” appears when network connection is not made.
System (System ID)
This information displays the system ID that is assigned to
this unit.
Use this menu to set the functions of the multi-zone
configuration.
■ Zone SP Assign
(Zone speaker assignment)
Use this feature to assign the speaker terminals for Zone 2
and Zone 3.
If you want use the external amplifiers for the all channels in the
main zone, you can use all the speaker terminals of this unit for
Zone 2 and/or Zone3 (pre-amplifier mode). Set “PREAMP
MODE” in “ADVANCED SETUP” to “ON” (page 114).
1 Press 9k / n to select the speaker terminal
and then press 9l / h repeatedly to select
the desired zone of which you want to use
the speakers.
M : Main zone
2 : Zone 2
3 : Zone 3
2 Press 9k / n to select “OK” and then press
9
ENTER to confirm the setting.
y
• To return to the previous menu level without change,
select “CANCEL” in step 2.
■ Component Assign
(Component assignment)
Use this feature to assign the COMPONENT VIDEO
(MONITOR OUT/ZONE OUT) jacks to the main zone or
another zone. Video signals are directed to the video
monitor in the selected zone if the corresponding input
source is selected.
Note
Choice Descriptions
Off
Does not accept the operations via LAN
network when this unit is in the standby mode.
On
Accepts the operations via LAN network when
this unit is in the standby mode.
Note
Note
Setup (Multi Zone)
Note
Choice Functions
Main
Select this setting when you want to connect the
video monitor in the main zone to the
COMPONENT VIDEO (MONITOR OUT/
ZONE OUT) jacks.
Zone2
Select this setting when you want to connect the
video monitor in the Zone 2 to the
COMPONENT VIDEO (MONITOR OUT/
ZONE OUT) jacks.
SP1
SP2
M23
Zone :
SP Terminal :
–23
OK
CANCEL
Zone4 Set
Zone OSD
Zone SP Assign
Component Assign
Party Mode Set