-EX Owner’s Manual V480360 R3 1 IP 16 100 CR Printed in Japan E
FCC INFORMATION (U.S.A.) 1. IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT! This product, when installed as indicated in the instructions contained in this manual, meets FCC requirements. Modifications not expressly approved by Yamaha may void your authority, granted by the FCC, to use the product. 2. IMPORTANT: When connecting this product to accessories and/or another product use only high quality shielded cables. Cable/s supplied with this product MUST be used. Follow all installation instructions.
■ Precautions • Do not touch the power plug with wet hands. Doing so is a potential electrical shock hazard. • The digital circuits of this unit may induce a slight noise into nearby radios and TVs. If noise occurs, relocate the affected equipment. • If the message “WARNING LOW BATTERY!” appears when you turn on this unit, contact your dealer as soon as possible about replacing the internal data backup battery. The unit will still operate correctly, but data other than the presets will be lost.
Thank you for choosing the DSP unit “DSP1D/DSP1D-EX”, specifically designed for the Yamaha PM1D digital audio mixing system. The DSP1D/DSP1D-EX is an engine controlled by the CS1D control surface. Be sure to ask an authorized Yamaha service engineer to install the boards and set up the unit. Never perform installation and setup by yourself. The following optional boards can be installed in the DSP1D.
A ENGINE ID A/B indicators These indicators indicate whether the DSP1D/ DSP1D-EX is connected to the engine A or engine B channel. Indicator A lights up if the DSP1D/DSP1D-EX is connected to the engine A channel jacks of the CS1D control surface (DIGITAL I/O jack A and CONTROL I/O jack A). Indicator B lights up if the DSP1D/DSP1DEX is connected to the engine B channel jacks of the CS1D control surface (DIGITAL I/O jack B and CONTROL I/O jack B).
L CONSOLE I/O 1, 2 slots O INPUT 1–10 slot Connect these slots to the DIGITAL I/O CONSOLE jacks of the CS1D control surface to transmit multichannel digital audio signals. Use a genuine Yamaha half-pitch 68-pin cable for connection. Use these slots to connect the OUTPUT connectors of an analog input unit AI8 series or DIO8 digital I/O unit series to input multi-channel digital audio signals to the DSP1D/DSP1D-EX. Use a genuine Yamaha half-pitch 68-pin cable for connection.
Slots (for IDB1D board) Unit Input channel DPS1D INPUT 1-48 & ST IN 1-4* DPS1D-EX INPUT 1-96 & ST IN 1-8 (DSP1D + IDB1D for expansion) *The DSP1D has an empty slot available for the IDB1D board. 460.8 Dimensions 450 ■ 480 ENGINE ID A B CONTROL I/O 1 2 INPUT CONFIGURATION 48CH 96CH 408.7 9.5 399.2 POWER ON/ OFF unit: mm • Specifications and appearance are subject to change without notice for improvement.
For details of products, please contact your nearest Yamaha representative or the authorized distributor listed below. Pour plus de détails sur les produits, veuillez-vous adresser à Yamaha ou au distributeur le plus proche de vous figurant dans la liste suivante. NORTH AMERICA CANADA Yamaha Canada Music Ltd. 135 Milner Avenue, Scarborough, Ontario, M1S 3R1, Canada Tel: 416-298-1311 U.S.A. Yamaha Corporation of America 6600 Orangethorpe Ave., Buena Park, Calif. 90620, U.S.A.