User Manual

PM5DV2/DSP5D Editor Owner’s Manual

❏ COMPRESSOR

Except for the fact that the COMP LINK GROUP is A–H, and that the types of signal that can be selected for key-

in are different, this is the same as for the compressor of an input channel (➥ p.25).

❏ INSERT

Except for the fact that the insert points that can be selected are different, this is the same as for the insert settings

of an input channel (➥ p.26).

❏ EQUALIZER

This is the same as the equalizer settings of a MIX channel (➥ p.32).

❏ DELAY

This is the same as for the delay settings of an input channel (➥ p.28).

❏ DCA GROUP / MUTE GROUP / SAFE

These are the same as the DCA Group / Mute Group / Safe settings of a MIX channel (➥ p.33).

❏ Pan / Fader

A BALANCE

Adjusts the left/right output balance of the STEREO A/B channel.

B ON

This switches the STEREO A/B channel on/off. This is linked with the STEREO [ON]

key in the STEREO A/B channel strip of the PM5D panel.

C MONO (ST B channel only)

Switches the ST B channel between stereo/mono.

D Fader

Adjusts the output level of the STEREO A/B channel. This is linked with the STEREO

fader in the STEREO A/B channel strip of the PM5D panel. The current value is shown

in the numerical box immediately below. A level meter is shown beside the fader.

E CUE

This button cue-monitors the signal of the STEREO A/B channel. This is linked with

the STEREO [CUE] key in the STEREO A/B channel strip of the PM5D panel. If SOLO

is active, this will function as SOLO.