User Manual

Advanced Setup

DTX502

4. Turn the Data Dial to set the pad type (w). Refer to the table below for settings.

(S): Only the head trigger of the DT50S will produce a sound.

*: If mounting a DT50S on a bass drum, such as in the Yamaha Junior Kit, set the Pad Type parameter to “DT50K”.

2-2. Saving Pad Types

Save your pad type settings on the drum trigger module as a User trigger setup to ensure they are not lost.

1. Press the [SAVE/ENTER] button.

2. Turn the Data Dial to select the User trigger setup number (18 to 33) in which you wish to save your settings.

3. If necessary, change the setup name. Press the [<]/[>] buttons to move the cursor to the character you wish to change, and

then turn the Data Dial to change it.

4. Press the [SAVE/ENTER] button. To cancel the process without saving any settings, press the [ ] button.

5. To proceed, press the [SAVE/ENTER] button once again.

2-3. Selecting a Voice

Select a voice for each input jack.

1. Press the [KIT] button to access the Kit Mode.

2. Navigate to the KIT2 page using the [<]/[>] buttons.

3. Strike the head or rim whose instrument voice(s) you wish to change. Alternatively, you can change the selection by holding

down the [SHIFT] button and pressing the [<]/[>] buttons.

This changes the instrument to which the voice will be assigned.

4. Use the [<]/[>] buttons to move the cursor to the voice category (q) and/or voice number (w), and turn the Data Dial to

change the voice.

Acoustic drum on which the

trigger is mounted

Input jack on drum trigger module

[qSNARE]

[wTOM1/!0], [eTOM2/!1],

[rTOM3/!2], or [uKICK/i]

DT50S

Snare DT50S(S) SN DT50S SN

Tom DT50S(S) tomH DT50S tomH

Floor tom DT50S(S) tomL DT50S tomL

DT50K Bass drum

(*)

DT50K DT50K

Destination for saving

Voice assignment destination