Owner's Manual

6-37
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
5
6
7
8
9
3
2
1
3. Elevate the front wheel by plac-
ing a suitable stand under the
engine.
4. Loosen the wheel axle holder
nuts.
5. Remove the wheel axle and the
front wheel. Make sure the
motorcycle is properly supported.
NOTE:
Do not depress the brake lever when
the disc and caliper are separated.
EAU03104
Front wheel installation
1. Install the speedometer gear unit
housing into the wheel hub.
Make sure the speedometer gear
unit housing is installed with the
projections meshed into the
slots.
2. Lift up the wheel between the
front fork legs and guide the
brake disc between the brake
pads. Make sure there is enough
gap between the brake pads
before inserting the brake disc.
1. Speedometer cable
2. Axle holder nut (×4)
3. Wheel axle
3. Make sure the slot in the
speedometer gear unit fits over
the stopper on the front fork
outer tube.
4. Install the wheel axle and let the
motorcycle down.
5. Tighten the wheel axle the speci-
fied torque.
Tightening torque:
Wheel axle:
58 Nm (5.8 m0kg)
3MB-9-E7 12/27/00 2:52 PM Page 73