Service manual
CHAS
DISASSEMBLING THE FRONT BRAKE CALIPER/
DISASSEMBLING THE REAR BRAKE CALIPER
4-19
a Blow compressed air into the brake hose
joint opening a to force out the piston from
the brake caliper.
ss
WARNING
• Cover the brake caliper piston with a rag.
Be careful not to get injured when the
piston is expelled from the brake caliper.
• Never try to pry out the brake caliper pis-
ton.
b. Remove the clip using a thin screwdriver
CAUTION
• When removing the clip, take care not to
damage the dust seal and caliper body.
c. Remove the brake caliper piston seals.
EAS00626
DISASSEMBLING THE REAR BRAKE
CALIPER
NOTE:
Before disassembling the brake caliper, drain
the brake fluid from the entire brake system.
1. Remove:
• Protector (Caliper body)
• Union bolts
• Copper washers
• Retaining bolt (Caliper body)
NOTE:
Put the end of the brake hose into a container
and pump out the brake fluid carefully.
2. Remove:
• Brake pads
• Shim (brake pads)
• Pad springs
Refer to the “BRAKE PAD REPLACE-
MENT” section.
4
1
2
3
3
1
2
(a)