Service manual

CHAS
ASSEMBLING AND INSTALLING THE FRONT AND
REAR BRAKE CALIPER
4-28
4. Install:
• Piston seal 
• Dust seal 
• Clip 
• Caliper piston 
ss
WARNING
Always use new piston seal and dust seal.
CAUTION
Install the clip into the slot on the caliper
body correctly.
5. Install:
• Caliper bracket 
6. Install:
• Pad springs
• Brake pads
Refer to the “BRAKE PAD REPLACE-
MENT” section.
7. Install:
• Caliper body 
NOTE:
Apply the lithium soap-base grease onto the
caliper guide shaft and retaining bolt.
CAUTION
• Take care no to allow the brake pads to
be smeared by grease.
• Wipe off any unnecessary grease that
comes out of place.
Caliper bracket:
35 Nm (3.5 m•kg, 25ft•lb)
Retaining bolt (Caliper body):
18 Nm (1.8m•kg, 13ft•lb)
1
2