Service manual

CHAS
ASSEMBLING AND INSTALLING THE FRONT AND
REAR BRAKE CALIPER
4-32
NOTE:
When installing the caliper piston , be sure to
have it’s open end facing the caliper cylinder
4. Install:
• Caliper bracket 
• Rear wheel
Refer to the “REAR WHEEL INSTALLA-
TION” section.
NOTE:
Be sure the boss on the swingarm correctly
engages with the locating slot on the caliper
bracket.
5. Install:
• Pad springs 
• Brake pads 
• Shim 
Refer to the “BRAKE PAD REPLACE-
MENT” section.
6. Install:
• Caliper body 
NOTE:
Apply the lithium-soap base grease onto the
caliper guide shaft and retaining bolt
CAUTION
• Take care not to allow the brake pads to
be smeared by grease.
• Wipe off any unnecessary grease that
comes out of place.
Retaining Bolt (Caliper body):
18 Nm (1.8 m•kg, 13 ft•lb)
1
1
1
2
3