Service manual

GEN
INFO
CHECKING THE CONNECTIONS
1-4
EAS00026
CHECKING THE CONNECTIONS
Check the leads, couplers, and connectors for
stains, rust, moisture, etc.
1. Disconnect:
• lead
• coupler
• connector
2. Check:
• lead
• coupler
• connector
Moisture

Dry with an air blower.
Rust/stains

Connect and disconnect
several times.
3. Check:
• all connections
Loose connection

Connect properly.
NOTE:
If the pin  on the terminal is flattened, bend
it up.
4. Connect:
• lead
• coupler
• connector
NOTE:
Make sure all connections are tight.
5. Check:
• continuity
(with the pocket tester)
NOTE:
• If there is no continuity, clean the terminals.
• When checking the wire harness, perform
steps (1) to (3).
• As a quick remedy, use a contact revitalizer
available at most part stores.
Pocket tester
90890-03112, YU-3112